Pond Aeration Requirement
Calculator

Inputs

Required aeration power (W)
20

Results

Required aeration power (W)
20
Required aeration power (kW)
0.02

Pool and aquarium results

Required aeration power (W)20
Required aeration power (kW)0.02

formula-map diagram

Required aeration power (W)
20
Required aeration power (kW)
0.02

Pool and aquarium relationship

Formula

P = surface area × W/m² × fish load factor

= 20

Note

This is a simplified model: it applies a standard geometric or physical formula to the numbers you entered. Volumes assume a regular shape and an even average depth, and the kidney shape uses the common 0.45 × (A + B) × L area approximation. Chemical doses convert a target change into a product mass using the strength or label dose you enter, because the amount of active ingredient varies from product to product; they ignore pH, temperature, buffering, sunlight, bather load and existing chemical interactions. Heating uses Q = m × c × ΔT with c = 4186 J/kg·K and ignores heat losses to air, ground and evaporation; evaporation and cover figures use the rate you enter, not local weather. Aquarium stocking by surface area is a rule of thumb, not a biological limit. Always follow the product label and test the water before and after dosing, and consult a pool or aquarium professional for anything you are unsure about.

Example: with the default inputs, calculator.pool.required_aeration_w is 20.

More in Pool and aquarium

See all →

Frequently asked questions

How is the required pond aeration power calculated?+

The calculator multiplies the pond surface area by the aeration power per m² and by a fish load factor: P = surface area × W/m² × fish load factor. The result is in watts and kilowatts.

What is the fish load factor?+

It is a multiplier you set: 1 means normal stocking, and a higher value raises the result for a more heavily stocked pond. The calculator does not derive it from fish numbers.

Where does the W/m² value come from?+

You enter it yourself; the default is 1 W/m². The calculator does not check it against any standard, so use the figure given by your equipment supplier.

Does the calculation use pond volume or depth?+

No. Only surface area, the W/m² figure and the fish load factor are used.

Is this a guarantee of enough oxygen?+

No. It is a rule-of-thumb estimate based on your inputs, not a guarantee of water quality or fish health. Check with a pond specialist if fish are at risk.