Wind Power Density
Calculator
Results
- Wind power density (W/m²)
- 313.6
- Wind power density (kW/m²)
- 0.3136
Weather results
| Wind power density (W/m²) | 313.6 |
| Wind power density (kW/m²) | 0.3136 |
formula-map diagram
- Wind power density (W/m²)
- 313.6
- Wind power density (kW/m²)
- 0.3136
Weather relationship
Formula
P/A = ½×ρ×v³ (kinetic-energy flux of moving air, W/m²)= 313.6
Note
This is a simplified model: it applies the published standard formula to the numbers you entered and ignores local terrain, radiation, precipitation type and instrument error. Wind chill is the 2001 NWS/Environment Canada regression, valid at or below 10 °C with wind at or above 4.8 km/h; the heat index is the Rothfusz regression, reliable above about 27 °C; dew point uses the Magnus approximation (a = 17.27, b = 237.7 °C) over liquid water; wet bulb uses Stull's approximation at standard sea-level pressure; pressure and density altitude assume the International Standard Atmosphere and dry air. Do not use these results for aviation, structural or safety decisions without an official forecast or a qualified professional.
Example: with the default inputs, calculator.weather.wind_power_density_wm2 is 313.6.
More in Weather and climate
See all →Frequently asked questions
What does wind power density measure?+
It is the kinetic energy flux of moving air through one square metre, computed as P/A = ½ × ρ × v³. The result is in W/m² and also in kW/m².
What inputs does it need?+
Air density in kg/m³ (the default is 1.225) and wind speed in m/s. Both must be positive.
Why does wind speed matter so much?+
Speed is cubed in the formula, so doubling the wind speed multiplies the power density by eight. Density only scales the result linearly.
Is this the power a turbine will produce?+
No. It is the power available in the wind per unit area, before any turbine efficiency, rotor size or other losses. Real output is lower.
Can I use a single speed for a whole site?+
The formula uses the one speed you enter. Real winds vary over time, so an average speed can understate the energy; treat the result as a rough estimate, not a site assessment.