Thread Length Hand Sewing
Calculator

Inputs

Base thread length (mm)
2,400

Results

Base thread length (mm)
2,400
Thread needed (mm)
2,880
Thread needed (cm)
288
Thread needed (m)
2.88

Craft results

Base thread length (mm)2,400
Thread needed (mm)2,880
Thread needed (cm)288
Thread needed (m)2.88

formula-map diagram

Base thread length (mm)
2,400
Thread needed (mm)
2,880
Thread needed (cm)
288
Thread needed (m)
2.88

Formula breakdown

Formula

L = stitches × length per stitch × (1 + waste)

= 2400

Note

Simplified model: these are standard craft estimates based on rectangular layouts, quoted gauge and nominal densities. Real fabric nap, directional prints, shrinkage, pattern matching, yarn lots and supplier SAP values vary, so always make a swatch or test piece and buy a little extra.

Example: with the default inputs, calculator.crafts.base_thread_length_mm is 2400.

More in Crafts and sewing

See all →

Frequently asked questions

How is the thread length calculated?+

It multiplies the number of stitches by the thread length per stitch, then adds your waste percentage. The formula is stitches × length per stitch × (1 + waste).

What should I enter for thread length per stitch?+

Enter the total thread consumed by one stitch in mm, including the thread that goes through the fabric. The default is 12 mm; measure a few of your own stitches for a better value.

What is the waste percentage for?+

It adds a margin, 20% by default, for knots, tails and thread lost at the start and end. Increase it if you rethread often.

Which units are shown?+

The result is shown in mm, cm and metres, plus the base length before waste, so you can compare with the length of your spool or needle thread.

Is this exact?+

No, it is an estimate. Fabric thickness, stitch type and tension change how much thread each stitch uses, so adjust the length per stitch to match your work.