Taper Jig Angle
Calculator

Inputs

Taper angle (degrees)
5.710593

Results

Taper angle (degrees)
5.710593
Width difference (mm)
30
Taper per 300 mm
30

Results

Taper angle (degrees)5.710593
Width difference (mm)30
Taper per 300 mm30

formula-map diagram

Taper angle (degrees)
5.710593
Width difference (mm)
30
Taper per 300 mm
30

Formula map

Formula

θ = atan((Wlarge − Wsmall) ÷ L)

= 5.7105931374996

Note

This result is a simplified model; verify against your shop's own tolerances and material data before cutting.

Example: with the default inputs, calculator.woodwork.taper_angle_degrees is 5.710593137499643.

More in Woodworking and metalwork

See all →

Frequently asked questions

How do I find the angle for a taper jig?+

Enter the taper length and the widths at the large and small ends. The angle is atan((large width − small width) ÷ length). The defaults, 80 mm to 50 mm over 300 mm, give about 5.71 degrees.

What is the width difference result?+

It is the large-end width minus the small-end width, in mm. This is the total amount the piece narrows along its length.

What does taper per 300 mm mean?+

It rescales the taper to a 300 mm run: (difference ÷ length) × 300. It lets you compare tapers of different lengths on one basis.

Can the small end be zero?+

Yes, the small-end width accepts 0, which gives a taper to a point. The large end and length must be above zero.

Does it account for blade kerf or jig setup?+

No. It computes only the geometric angle from the three measurements you enter, so set up and test on scrap before cutting good stock.