Landing Distance Safety Margin
Calculator

Inputs

Margin (ft)
1,400

Results

Margin (ft)
1,400
Margin (%)
66.666666
Required-to-available ratio
0.6

Aviation and marine results

Margin (ft)1,400
Margin (%)66.666666
Required-to-available ratio0.6

formula-map diagram

Margin (ft)
1,400
Margin (%)
66.666666
Required-to-available ratio
0.6

Aviation and marine relationship

Formula

Margin = runway available − landing distance required

= 1400

Note

This is a simplified model: it applies a standard navigation, performance or seamanship formula to the numbers you entered. True airspeed and density altitude use the ISA troposphere model for dry air and ignore humidity, compressibility and instrument or position error, so they are not a substitute for your aircraft's flight manual or an air data computer. Wind, climb, descent and fuel figures assume a steady wind and a constant speed and fuel flow for the whole leg; they ignore manoeuvring, holding, taxi and start-up fuel, terrain, turbulence and air traffic control routing. Takeoff distance scales an entered sea level figure by a rule-of-thumb percentage per 1000 ft of density altitude and is not a certified performance chart. Weight and balance results depend entirely on the arms and weights you enter and must be checked against the approved loading envelope. Hull speed is the classic 1.34 × √LWL displacement estimate, boat fuel burn is a horsepower-based approximation, anchor scope is a rule of thumb, and the rule of twelfths is a linear approximation of a sinusoidal tide that does not hold in all locations. Always use official charts, tide tables, the aircraft or vessel manuals and current weather, and treat these numbers as planning estimates only.

Example: with the default inputs, calculator.aviation.margin_ft is 1400.

More in Aviation and marine

See all →

Frequently asked questions

What does this calculator compute?+

From the landing distance required and the runway length available, both in feet, it gives the margin in feet, the margin as a percentage of the distance required, and the ratio of required to available.

How is the margin calculated?+

Margin (ft) = runway available − landing distance required. Margin (%) = that margin ÷ landing distance required × 100.

What inputs do I need?+

Landing distance required (ft) and runway length available (ft); both must be greater than zero. Defaults are 2,100 ft and 3,500 ft.

What does a negative margin mean?+

The landing distance you entered is longer than the runway you entered, so the margin in feet and in percent both come out negative.

Does it account for wind, slope or surface?+

No. It only compares the two figures you provide, so any such corrections must already be included in the landing distance required. It is not a substitute for the aircraft's performance data or pilot judgment.